12-41
6. Remove the oil filter case by turning it counter-
clockwise. Use a rag to prevent oil from drip-
ping down.
7. Clean the O-ring contact surface of the oil filter
support and the O-ring groove of the oil filter
case.
8. Replace the O-ring of the oil filter case with a
new one. Apply a light coat of engine oil to the
new O-ring before installing it.
CAUTION
Use only the O-ring supplied with a new replace-
ment filter element.
9. Replace the filter element with a new one;
use only a genuine filter element.
10. Install the new filter element with its holed end
facing down. Insert the holed end of the filter
element snugly into the groove inside the oil fil-
ter support.
11. Install the air plug to the oil filter case.
If the engine oil is replaced, add the necessary
quantity of engine oil. P. 12-26
12. Tighten the oil filter case.
13. After cranking the engine according to the
instructions on page 5-8, start the engine.
14. Start the engine and check for oil leakage.
15. Stop the engine and, after letting it stand for
more than 10 minutes, check the oil level.
Tightening
torque
1.5 ± 0.6 N·m
(1.1 ± 0.4 ft.lbs.,
0.15 to 0.06 kgf·m)
Tightening
torque
25 to 30 N·m
(18.4 to 22.1 ft.lbs.,
2.5 to 3.0 kgf·m)
Z21175
Z21178
FE_FG.book Page 41 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
