Indication lamps
E00501600100
Turn-signal indication lamps/
Hazard warning indication
lamps
E00501700172
These
indication lamps blink on and off
when a turn-signal lamp is operating.
NOTE
l
If the blinking is too fast, the
cause may be a blown lamp bulb
or a faulty turn-signal connection.
When the hazard warning lamp switch is
pressed, all turn-signal lamps will flash
on and off continuously.
High-beam indication lamp
E00501800160
This
indication lamp illuminates when
the high-beam is used.
Front fog lamp indication lamp
E00501900321
This
lamp illuminates while the front
fog lamps are on.
Rear fog lamp indication lamp
E00502000101
This
lamp illuminates while the rear fog
lamp is on.
Position lamp indication lamp
E00508900160
This
indication lamp illuminates while
the position lamps are on.
Warning lamps
E00502400147
Brake warning lamp
E00502502100
This
lamp illuminates when the ignition
switch is turned to the “ON” position,
and goes off after a few seconds.
Always make sure that the lamp goes off
before driving.
With the ignition switch in the “ON” po-
sition, the brake warning lamp illumi-
nates under the following conditions:
l
When the parking brake has been
applied.
l
When the brake fluid level in the
reservoir falls to a low level.
l
When the brake force distribution
function is not operating correctly.
CAUTION
l
In
the situations listed below,
brake performance may be com-
promised or the vehicle may be-
come unstable it brakes are ap-
plied suddenly; consequently,
avoid driving at high speeds or
applying the brakes suddenly.
Furthermore, immediately the
vehicle should be brought to a
stop in a safe location and we
recommend you to have it
checked.
CAUTION
• The
brake warning lamp
does not illuminate when
the parking brake is applied
or does not turn off when
the parking brake is re-
leased.
• The brake warning lamp
and the ABS warning lamp
illuminate at the same time.
For details, refer to “ABS
warning lamp” on page
4-32.
• The brake warning lamp re-
mains illuminated while
driving.
l
The vehicle should be brought
to a halt in the following man-
ner when brake performance
has deteriorated.
• Depress the brake pedal
harder than usual.
Even if the brake pedal
moves down to the very end
of its possible stroke, keep it
pressed down hard.
• Should the brakes fail, use
engine braking to reduce
your speed and carefully
pull the parking brake lever.
Depress the brake pedal to
operate the stop lamp to
alert the vehicles behind you.
Instruments and controls
3-34
3
To Next Page
Loading...
Need help?
General
