EasyManuals Logo
Home>Mitsubishi>Automobile>Lancer Evolution

Mitsubishi Lancer Evolution User Manual

Mitsubishi Lancer Evolution
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
Seat belt inspection
E00406300475
l
Check
the belts for cuts, worn or frayed web-
bing and for cracked or deformed metallic
parts. Replace the belt assembly if defective.
l
A dirty belt should be cleaned with neutral de-
tergent in warm water. After rinsing in water,
let it dry in the shade. Do not attempt to
bleach or re-dye the belts because this affects
their characteristics.
WARNING
l
We
recommend you to have all seat belt
assemblies including retractors and at-
taching hardware inspected after any col-
lision. We recommend that seat belt as-
semblies in use during a collision be re-
placed unless the collision was minor and
the belts show no damage and continue to
operate properly.
l
Do not attempt to repair or replace any
part of the seat belt assemblies; we recom-
mend you to have this work done by a
MITSUBISHI MOTORS Authorized
Service Point. Incorrect repair or replace-
ment could reduce the effectiveness of the
belts and could result in serious injury in
the event of a collision.
l
Once the pretensioner has activated, it
cannot be re-used.
It must be replaced together with the re-
tractor.
Supplemental restraint system
(SRS) - airbag
E00407201843
The information written in this Supplemental Re-
straint System (SRS) section contains important
points concerning the driver, front passenger, driv-
er’s knee, side and curtain airbags.
The SRS driver and front passenger airbags are de-
signed to supplement the primary protection of the
driver and front passenger side seat belt systems by
providing those occupants with protection against
head and chest injuries in certain moderate- to-se-
vere frontal collisions.
The SRS driver and front passenger airbags em-
ploy a dual stage airbag system. The SRS driver
and front passenger airbag is controlled by the im-
pact sensors (at the front of the vehicle) and the con-
trol unit (near the centre of the vehicle at floor level).
The SRS driver’s knee airbag is designed to supple-
ment the primary protection of the driver’s seat belt
system. It can reduce the forward movement of the
driver’s lower legs and provide increased overall
body protection in certain moderate-to- severe fron-
tal collisions.
The SRS side airbags are designed to supplement
properly worn seat belts and provide the driver and
front passenger with protection against chest and ab-
domen injuries in certain moder-ate-to-severe side
impact collisions.
The SRS curtain airbags are designed to supple-
ment properly worn seat belts and provide the driv-
er and passenger with protection against head inju-
ries in certain moderate-to-severe side impact colli-
sions.
Seat and seat belts
2-18
2
OGEE12E1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Lancer Evolution and is the answer not in the manual?

Mitsubishi Lancer Evolution Specifications

General IconGeneral
BrandMitsubishi
ModelLancer Evolution
CategoryAutomobile
LanguageEnglish

Related product manuals