NOTE
l
On
vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner’s man-
ual for details.
Dead Lock System*
E00305100172
The
Dead Lock System helps to prevent theft.
When the keyless operation system has been used
to lock all of the doors, the Dead Lock System
makes it impossible to unlock the doors using the
inside lock knobs.
CAUTION
l
Do
not set the Dead Lock System when
someone is inside the vehicle. With the
Dead Lock System set, it is not possible to
unlock the doors using the inside lock
knobs. If you erroneously set the Dead
Lock System, unlock the doors using the
UNLOCK switch on the keyless opera-
tion key or the keyless operation function.
Setting the system
E00305200203
1. Turn
the ignition switch to the “LOCK” posi-
tion.
Also, if an emergency key was used to start
the engine, remove the key from the ignition
switch.
2. Get out of the vehicle. Close all of the doors.
3. Press the LOCK switch (A) on the keyless op-
eration key, or the driver or front passenger’s
door lock/unlock switch (B) to lock all of the
doors. The turn-signal lamps will blink once.
4. Press
the LOCK switch (A) on the keyless op-
eration key, or the driver or front passenger’s
door lock/unlock switch (B) again within
two seconds.
The turn-signal lamps will blink three times
to show that the Dead Lock System has been
set.
Locking and unlocking
1-25
1
To Next Page
Loading...
Need help?
General
