To lock and unlock the doors
E00311500054
Using the central door lock switch
All
of the doors can be locked or unlocked by press-
ing the central door lock switch on the driver’s door.
1- Lock
2-
Unlock
Type 2 (RHD vehicles)
E00311600042
NOTE
l
Each
of the doors can be locked or unlocked
independently by using the inside lock knob.
(except for the driver’s door)
l
Repeated continuous operation between lock
and unlock could activate the central door
locking systems built-in protection circuit
and prevent the system from operating. If
this occurs, wait about 1 minute before oper-
ating the inside lock knob or the key.
To lock and unlock the doors
E00311700069
Using the key on the driver’s door
Using
the key on the driver’s door locks or unlocks
all doors.
1- Lock
2-
Unlock
Using the inside lock knob on the driver’s door
Using the inside lock knob on the driver’s door
locks or unlocks all doors.
1- Lock
2-
Unlock
To unlock the doors
E00308700339
You can select the functions to unlock the doors
either
using the ignition switch position or using
the gearshift lever (Twin Clutch SST) position.
These functions are not activated when the vehi-
cle is shipped from the factory. To activate or de-
activate these functions, please contact a
MITSUBISHI MOTORS Authorized Service
Point.
Using the ignition switch position
All
doors will unlock whenever the ignition switch
is turned to the “LOCK” position.
Using the gearshift lever (Twin Clutch SST) posi-
tion
All doors will unlock whenever the gearshift lever
(Twin Clutch SST) is moved to the “P” (PARK) po-
sition with the ignition switch in the “ON” position.
Locking and unlocking
1-24
1
To Next Page
Loading...
Need help?
General
