NOTE
l
The
amount of steering wheel operation nec-
essary to illuminate the bending lamps
changes according to the vehicle speed. (The
lower the vehicle speed, the more steering
wheel operation is necessary.)
However, the lamps can be set before driving
to illuminate with just a small amount of steer-
ing wheel operation.
l
The AFS does not work in any of the follow-
ing circumstances:
• The shift lever is in the “R” position.
•
The lamp switch is in the “
” or
“OFF” position.
• The vehicle speed is 100 km/h (62 mph)
or higher.
Adaptive Front lighting System (AFS)
indications
E00525300404
Warning lamp
Warning display
In the event of an abnormality in the AFS, a warn-
ing
display appears in the information window of
the multi information display and the “AFS OFF”
warning lamp in the meter cluster flashes.
CAUTION
l
If the warning display is displayed, the sys-
tem may be malfunctioning. We recom-
mend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
NOTE
l
If
the AFS warning lamp flashes while you
are driving, stop the car in a safe place, turn
the ignition switch to the “ACC” or “OFF”
position, then restart the engine.
If the AFS warning lamp stays off, the AFS
is normal.
l
When the emergency spare wheel is fitted on
the vehicle, the AFS may not work normally.
Fit a standard wheel on the vehicle instead of
the emergency spare wheel as soon as possi-
ble.
Hazard warning flasher switch
E00506600596
Use
the hazard warning flasher switch when the ve-
hicle has to be parked on the road for any emergency.
The hazard warning flashers can always be operat-
ed, regardless of the position of the ignition switch.
Push the switch to turn on the hazard warning flash-
ers, all turn signal lamps flash continuously. To
turn them off, push the switch again.
Instruments and controls
3-43
3
To Next Page
Loading...
Need help?
General
