Refer to “Check engine warning lamp” on page
3-35 and follow the appropriate measures.
When the gearshift lever position display is not
showing
A safety device in the Twin Clutch SST has been
activated due to a possible malfunction in the Twin
Clutch SST.
Refer to “If the gearshift lever position display is
not showing” on page 4-19 and follow the appropri-
ate measures.
When
warning display is showing or when no
warning is showing in the multi-information dis-
play
A
safety device in the Twin Clutch SST has been
activated due to a possible malfunction in the Twin
Clutch SST or in the engine electronic control mod-
ule.
Perform the following procedure.
1. Park your vehicle in a safe place and stop the
engine.
2. Restart the engine.
If the vehicle moves and accelerates normally after
this procedure is performed, there is no malfunction.
However, if the vehicle does not move or acceler-
ate normally, or if this problem occurs repeatedly,
have the vehicle checked by a MITSUBISHI
MOTORS Authorized Service Point as soon as pos-
sible.
CAUTION
l
When the Twin Clutch SST fluid temper-
ature is high, the engine idle speed when
the vehicle is stopped may increase or the
vehicle will have a weak tendency to creep.
After that, if the Twin Clutch SST fluid
temperature rises even higher, the
warning display will appear.
Full-time 4WD
E00604900192
Full-time
4WD vehicles are propelled by engine
power distributed constantly and appropriately to
all 4 wheels.
Not only does this ensure better handling on dry,
paved roads but also permits better traction when
driving on slippery, wet or snow-covered roads and
when moving out of mud.
These vehicles, however, are not designed for off-
road use, and are unsuitable for driving on bum-
py ground that may cause excessive strain. Full-
time 4WD vehicles should be driven only under the
same conditions as are suitable for ordinary front-
wheel drive vehicles.
Starting and driving
4-27
4
To Next Page
Loading...
Need help?
General
