For longer waiting periods with the engine running,
place the gearshift lever in the “N” (NEUTRAL) po-
sition and apply the parking brake, while holding
the vehicle stationary with the service brake.
CAUTION
l
Do
not keep the vehicle in a stopped posi-
tion on an uphill slope by depressing the
accelerator pedal instead of the brake ped-
al.
The transmission may be damaged and
an accident may occur due to the follow-
ing conditions.
• The Twin Clutch SST fluid tempera-
ture will rise and can cause transmis-
sion damage.
CAUTION
• If
the vehicle is kept in a stopped posi-
tion by depressing the accelerator ped-
al instead of the brake pedal, the vehi-
cle will vibrate or “SLOW DOWN”
and the
warning display will ap-
pear
on the information screen in the
multi-information display to alert the
driver that the Twin Clutch SST fluid
temperature has risen.
After that, if the Twin Clutch SST flu-
id temperature rises even higher, the
transmission protection control will
operate.
If this occurs, the vehicle may sudden-
ly reverse as if the gearshift lever was
in the “N” (NEUTRAL) position and
cause an accident.
If the
warning display appears or
the
transmission protection control op-
erates, refer to “When warning dis-
play is showing” on page 4-23.
Parking
E00622400014
To park the vehicle, first bring it to a complete
stop,
fully engage the parking brake, and then
move the gearshift lever to the “P” (PARK) position.
If you are going to leave the vehicle unattended, al-
ways switch off the engine and carry the key.
NOTE
l
On
a slope, be sure to apply the parking
brake before moving the gearshift lever to
the “P” (PARK) position. If you move the
gearshift lever to the “P” (PARK) position be-
fore applying the parking brake, it may be dif-
ficult to disengage the gearshift lever from
the “P” (PARK) position when next you
drive the vehicle, requiring application of a
strong force to the gearshift lever to move
from the “P” (PARK) position.
What to do if the following occur with the Twin
Clutch SST
E00622500204
If there is a malfunction in the Twin Clutch SST or
engine
electronic control module, the following
may occur.
l
Twin Clutch SST does not shift.
l
Vehicle cannot move.
l
Twin Clutch SST acceleration is slow.
l
Vehicle does not creep.
l
“Shift shock” is large.
l
Shifting occurs at higher engine speed.
l
Response is slow.
If any of these occurs, perform the following proce-
dure.
When
warning display is showing
The temperature of Twin Clutch SST fluid is high.
Refer
to “Warning display” on page 4-23 and fol-
low the appropriate measures.
When the check engine warning lamp comes on
or blinking
There could be a malfunction in the engine electron-
ic control module.
Starting and driving
4-26
4
To Next Page
Loading...
Need help?
General
