After a while, check that the warning display
has gone out. If the display goes out, the vehicle
can be driven normally. If the warning display re-
mains on or comes on frequently, have the vehicle
checked by a MITSUBISHI MOTORS Authorized
Service Point.
CAUTION
l
If
the
warning display is shown, such
as
when the vehicle does not accelerate
while traveling even if the accelerator ped-
al is depressed, the vehicle may not be
able to be driven normally.
For safety, pay attention to your surround-
ings when driving the vehicle.
NOTE
l
If
the vehicle is continuously driven on hilly
roads or in a sporty manner, the vehicle may
vibrate.
This vibration is to alert the driver that the
Twin Clutch SST fluid temperature has ris-
en. It does not indicate a malfunction.
If this occurs, perform the same measures for
when the
warning appears. If the vibration
stops, the vehicle can be driven normally.
If vehicle is driven with warning displayed
If
the vehicle continues to be driven after the
warning display and “SLOW DOWN” appear, and
the
temperature of the Twin Clutch SST fluid con-
tinues to rise, the transmission protection control
may operate and cause the transmission to function
as if the gearshift lever was in the “N” (NEU-
TRAL) position.
(At
this time, the vehicle temporarily cannot be driv-
en.)
If this occurs, take the following measures.
1. Depress the brake pedal and stop the vehicle
in a safe place.
2. Place the gearshift lever in the “P” (PARK)
position, and then open the bonnet with the
engine running to cool the engine.
3.
After a while, check that the warning dis-
play has gone out, and then stop the engine if
the warning display has gone out.
4. If the engine can be restarted, the vehicle can
be driven normally.
If the warning display remains on or comes on fre-
quently, have the vehicle checked by a
MITSUBISHI MOTORS Authorized Service Point.
When warning display is showing
E00626900020
A safety device in the Twin Clutch SST has been
activated
due to a possible malfunction in the Twin
Clutch SST or in the engine electronic control mod-
ule.
If this occurs, perform the following procedure.
1. Park your vehicle in a safe place and stop the
engine.
2. Restart the engine.
If the
warning display goes out, there is no ab-
normal condition.
If
the warning display remains on or comes on fre-
quently, have the vehicle checked by a
MITSUBISHI MOTORS Authorized Service Point
as soon as possible.
CAUTION
l
If the warning display is shown, such
as
when the vehicle does not accelerate
while traveling even if the accelerator ped-
al is depressed, the vehicle may not be
able to be driven normally.
For safety, pay attention to your surround-
ings when driving the vehicle.
Operation of the Twin Clutch SST
E00622000081
CAUTION
l
Before selecting a position with the en-
gine running and the vehicle stationary,
fully depress the brake pedal to prevent
the vehicle from creeping.
The vehicle will begin to move as soon as
the Twin Clutch SST is engaged, the
brakes should only be released when you
are ready to drive away.
l
Depress the brake pedal with the right
foot at all times.
Using the left foot could cause driver move-
ment delay in case of an emergency.
l
To prevent sudden acceleration, never
race the engine when shifting from the
“P” (PARK) or “N” (NEUTRAL) position.
l
Operating the accelerator pedal while the
other foot is resting on the brake pedal
will affect braking efficiency and may
cause premature wear of brake pads.
Starting and driving
4-24
4
To Next Page
Loading...
Need help?
General
