Under normal conditions, the ABS warning lamp
only comes on when the ignition switch is turned
to the “ON” position and goes off a few seconds later.
CAUTION
l
Any
of the following indicates that the
ABS is not functioning and only the stand-
ard brake system is working. (The stand-
ard brake system is functioning normal-
ly.) If this happens, we recommend you to
have your vehicle inspected as soon as pos-
sible.
• When the ignition switch is in the
“ON” position, the warning lamp does
not come on or it remains on and does
not go off.
• The warning lamp comes on while driv-
ing.
• The warning display appears while
driving.
If the warning lamp/display illuminate
while driving
E00607301208
If only the ABS warning lamp/display illuminate
Avoid
hard braking and high-speed driving. Stop
the vehicle in a safe place.
Restart the engine and check to see whether the
lamp goes out after a few minutes driving; if it then
remains off during driving, there is no problem.
However, if the warning lamp/display do not disap-
pear, or if they come on again when the vehicle is
driven, we recommend you to have the vehicle
checked.
If the ABS warning lamp/display and brake warn-
ing lamp/display illuminate at the same time
Warning lamp
Warning display
The ABS and brake force distribution function may
not
work, so hard braking could make the vehicle
unstable.
Avoid hard braking and high-speed driving. Stop
the vehicle in a safe place and we recommend you
to have the vehicle checked.
NOTE
l
The ABS warning lamp and brake warning
lamp illuminate at the same time and the warn-
ing displays appear alternately on the infor-
mation screen in the multi-information dis-
play.
After driving on icy roads
E00618800091
After
driving on snow or icy roads, remove any
snow and ice which may have be left around the
wheels. On vehicles that have an ABS, be careful
not to damage the wheel speed sensors (A) or the
cables located at each wheel.
To Next Page
Loading...
Need help?
General
