EasyManuals Logo
Home>Mitsubishi>Automobile>Lancer Evolution

Mitsubishi Lancer Evolution User Manual

Mitsubishi Lancer Evolution
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #182 background imageLoading...
Page #182 background image
To deactivate
E00609700720
The
set speed driving can be deactivated as follows:
l
Press the “ON OFF” switch (A) (Cruise con-
trol will be turned off.)
l
Press the “CANCEL” switch (D).
l
Depress the brake pedal.
The set speed driving is deactivated automatically
in any of the following ways.
l
When
you depress the clutch pedal (on vehi-
cles with M/T).
l
When your speed slows to about 15 km/h
(9 mph) or more below the set speed because
of a hill, etc.
l
When your speed slows to about 40 km/h
(25 mph) or less.
l
When the Twin Clutch SST control mode is
set to “Sport” mode (on vehicles with Twin
Clutch SST).
Refer to “Twin Clutch SST control mode”
on page 4-19.
l
When the Active Stability Control (ASC)
starts operating.
Refer to “Active stability control (ASC)” on
page 4-34.
WARNING
l
On vehicles with Twin Clutch SST, al-
though the set speed driving will be deac-
tivated when shifting to the “N” (NEU-
TRAL) position, never move the gearshift
lever to the “N” (NEUTRAL) position
while driving.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deactivated as
follow:
l
When
the engine speed rises and approaches
the tachometer’s red zone (the red-coloured
part of the tachometer dial).
CAUTION
l
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the “ON OFF” switch to turn off
the cruise control and have your vehicle
inspected by a MITSUBISHI MOTORS
Authorized Service Point.
To resume the set speed
E00609800486
If
the set speed driving is deactivated by the condi-
tion described in “To deactivate” on page 4-41,
you can resume the previously set speed by press-
ing the “ACC RES” switch (C) while driving at a
speed of about 40 km/h (25 mph) or higher.
Under either of the following conditions, however,
using
the switch does not allow you to resume the
previously set speed. In these situations, repeat the
speed setting procedure:
l
The “ON OFF” switch is pressed.
l
The ignition switch is turned OFF.
l
“CRUISE” indication lamp is turned OFF.
Starting and driving
4-41
4
OGEE12E1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Lancer Evolution and is the answer not in the manual?

Mitsubishi Lancer Evolution Specifications

General IconGeneral
BrandMitsubishi
ModelLancer Evolution
CategoryAutomobile
LanguageEnglish

Related product manuals