To listen to the radio
E00709000522
1. Press
the PWR switch (1) or the AM/FM but-
ton (2) to turn ON the radio.
Press the PWR switch again to turn OFF the
radio.
2. Press the AM/FM button (2) to select the de-
sired band.
3. Turn the TUNE switch (4), or press the
SEEK button (5 or 6) or memory select but-
tons (3) to tune into a radio broadcasting sta-
tion.
To tune the radio
E00709100419
Automatic tuning
After
pressing the SEEK button (5 or 6), a receiva-
ble station will be automatically selected and recep-
tion of the station will begin.
Manual tuning
The frequency changes every time the TUNE
switch (4) is turned. Turn the switch to select the
desired radio broadcasting station.
To enter frequencies into the memory
E00716100857
Manual setting
You
can assign to the memory select buttons (3) a
maximum of 18 stations in the FM band (6 FM1, 6
FM2 and 6 FM3 stations) and 6 stations each in the
MW and LW band. (Stations already assigned to
the memory select buttons are replaced by any new-
ly assigned stations.)
Follow the steps described below.
1. Press
the SEEK button (5 or 6), or turn the
TUNE switch (4) to tune to the frequency
you wish to keep in the memory.
2. Press one of the memory select buttons (3) un-
til it beeps.
The sound will be momentarily interrupted
while the frequency is being entered into the
memory. The number of the button matching
the entry in the memory as well as the fre-
quency is displayed.
3. The preset memory setting is retrieved by
pressing the button and then releasing it with-
in 1 second.
NOTE
l
Disconnecting
the battery terminal erases all
the radio frequencies stored in the memory.
Automatic setting
With the method, all manually set stations in the
band currently selected for reception are replaced
with stations in the same band that are automatical-
ly selected in order of signal strength.
The radio automatically selects 6 stations in the
FM band (FM3 station only) and 6 stations each in
the MW and LW band.
Follow the steps described below.
1. With the radio mode selected, hold down the
AM/FM button (2) for 2 seconds or longer.
The 6 stations with the best signal strength
will automatically be assigned to the memo-
ry select buttons (3), with the lowest-frequen-
cy station being assigned to the lowest-num-
ber button.
2. When you subsequently press a memory se-
lect button to select a channel number, the ra-
dio will begin receiving the station assigned
to that number.
NOTE
l
If you press the AM/FM button (2) for 2 sec-
onds or longer while tuning in the FM1 or
FM2 band, the radio will automatically
switch to the FM3 band, where the automatic
seeking/storing will be activated.
For pleasant driving
5-13
5
To Next Page
Loading...
Need help?
General
