NOTE
l
If
the SEEK button (7 to 8) is pressed, the ra-
dio will try to find out another broadcast of
the same program type as currently selected.
l
If no station is found with your desired PTY,
the display will show “EMPTY” for about 5
seconds and the radio will return to the previ-
ous station.
How to enter PTYs in the memory
E00721400076
As many as 6 PTYs can be entered in the memory.
Follow the steps described below.
1. Press
either the TUNE switch (6) to tune the
PTY to be entered in the memory.
2. Press one of the memory select buttons (3)
for 2 seconds or longer. The sound will be
momentarily interrupted while the PTY is be-
ing entered into the memory. The number of
the button corresponding to the entry into the
memory and the PTY are displayed.
3. The preset memory setting is retrieved by
pressing the button and then releasing it with-
in about 2 seconds.
To change the language of PTY display
E00721500136
You can select your favourite language among Eng-
lish,
French, German, Swedish, Spanish and Italian.
1. Press the TUNE switch (6) for 2 seconds or
longer to select the language of PTY display
mode. Refer to “Function setup mode” on
page 5-31.
2. Turn the TUNE switch (6) to select a language.
NOTE
l
After
selecting a mode, you can leave the func-
tion setup mode by taking either of the fol-
lowing steps:
• Press the TUNE switch (6) for at least 2
seconds.
• Make no entry for 10 seconds.
Traffic information
E00721600124
The radio will automatically tune in to traffic infor-
mation broadcasts while receiving FM broadcasts
or playing compact discs.
To select this function, follow the instructions below.
1. Press the TP button (4). The display will
show “TP” (11).
If the RDS data can be read, the display will
show “RDS” (10). If not, the display will
show “NO RDS” for about 5 seconds.
2. If the radio detects traffic information on ei-
ther the station currently selected or another
station, the display will show “TRAF INF”
for 5 seconds followed by a 2-second indica-
tion of the frequency. Then, it will show the
name of the station broadcasting the traffic in-
formation to which you will listen. The vol-
ume level is set separately for listening to nor-
mal audio programmes and for listening to
traffic information. The volume level will
therefore change automatically to that set
when traffic information was last received.
When the traffic information broadcast is
over, the radio will return to the previously re-
ceived program and to the corresponding vol-
ume level.
3. Press the TP button (4) to return to the previ-
ous condition.
NOTE
l
While “TP” is illuminated, the radio stops on-
ly at TP stations, even if the TUNE switch
(6) is turned.
For pleasant driving
5-30
5
To Next Page
Loading...
Need help?
General
