Playback starts from the folder next to the one cur-
rently playing.
The folder number will blink while the scan mode
is selected.
To exit this mode, press the button again.
NOTE
l
Once the cueing playback ends, playback
will start from the track at the beginning of
the folder next to the one that was playing
when the cueing started.
To switch the display
E00759300012
You can display titles with tag information.
Folder title
The
display changes as follows every time the
DISP button (5) is pressed during playback.
Folder title → File title → Normal display
Tag information
1. Press and hold the DISP button (5) until you
hear a beep to show “TAG” in the display.
2. The
display changes as follows every time
the DISP button (5) is pressed briefly.
Album title → Track title → Artist name →
Genre (vehicles with Bluetooth
®
2.0 inter-
face) → Normal display
NOTE
l
Press
and hold the DISP button (5) again un-
til you hear a beep, and the tag information
display returns to the folder title display.
l
Up to 10 characters are shown in the display
at once. If the title is cut off in the middle,
press the PAGE button (4). The next charac-
ters are displayed every time this button is
pressed.
l
If no title is stored, “NO TITLE” is shown in
the display.
l
Characters that cannot be displayed are sub-
stituted by “•”.
To play USB memory device tracks
via
voice operation (vehicles with Blue-
tooth
®
2.0 interface)
E00759400114
Desired tracks can be selected and played from
your USB memory device by “Artist”, “Album”,
“Playlist” and “Genre” using voice commands.
For information concerning the voice recognition
function or speaker registration function, refer to
“Bluetooth
®
2.0 interface” on page 5-64.
The playback sequence of tracks is the same as
when an iPod is connected. Refer to the “To play
iPod tracks via voice operation” on page 5-42.
Preparation for voice operation
To use the voice operation, press the SPEECH but-
ton (1) first.
For pleasant driving
5-48
5
To Next Page
Loading...
Need help?
General
