Mitsubishi MIRAGE Service Manual

Multi-information display
Features and controls 5-69
5
1. When you lightly press the multi-informa-
tion display switch a few times, the infor-
mation display switches to the driving
range display.
Refer to “Information display” on page
5-63.
2. Each time you press the multi-information
display switch for 1 second or more on
driving range display, you can switch
reset mode for average fuel consumption.
(A: Auto reset mode, B: Manual reset
mode)
 When the average fuel consumption is
being displayed, if you hold down the
multi-information display switch, these
calculations will be reset to zero.
 When the following operation is per-
formed, the mode setting changes auto-
matically from manual to auto.
[Except for vehicles equipped with the
F.A.S.T.-key]
Turn the ignition switch to the “ON” posi-
tion from the “ACC” or “OFF” position.
[For vehicles equipped with the F.A.S.T.-
key]
Change the operation mode to ON from
ACC or OFF.
 When the average fuel consumption is
being displayed, if you hold down the
multi-information display switch, these
calculations will be reset to zero.
 When the engine switch or the operation
mode is in the following conditions, the
average fuel consumption display will
automatically reset.
[Except for vehicles equipped with the
F.A.S.T.-key]
The ignition switch has been set to the
“ACC” or “OFF” position for about 4
hours or more.
[For vehicles equipped with the F.A.S.T.-
key]
The operation mode has been set to ACC
or OFF for about 4 hours or more.
N00557100156
The fuel consumption display unit can be
changed. The distance and amount units are
also switched to match the selected fuel con-
sumption unit.
1. When you lightly press the multi-informa-
tion display switch a few times, the infor-
mation display switches to the average
fuel consumption display.
Refer to “Information display” on page
5-63.
2. Press and hold the multi-information dis-
play switch for about 5 seconds or more
until buzzer sound is heard twice.
Manual reset mode
Auto reset mode Manual reset mode
Auto reset mode
NOTE
 The average fuel consumption display can be
reset separately for the auto reset mode and
for the manual reset mode.
 Disconnecting the battery cable will erase
from memory the manual reset mode or auto
reset mode setting for the average fuel con-
sumption display.
 The initial (default) setting is “Auto reset
mode”.
Changing the fuel consumption
display unit
BK0212400US.book 69 ページ ２０１４年４月１日 火曜日 午後２時２１分
Information Provided by:

Mitsubishi MIRAGE Specifications

General

Brand	Mitsubishi
Model	MIRAGE
Category	Automobile
Language	English