EasyManuals Logo

Mitsubishi MIRAGE Service Manual

Mitsubishi MIRAGE
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #134 background imageLoading...
Page #134 background image
Warning lights
Features and controls 5-73
5
N00520600313
This light comes on in the event of a malfunc-
tion in the charging system or when the igni-
tion switch is turned to the “ON” position
(engine off) or the operation mode is put in
ON. When the engine is started, the light
should go out. Check to make sure that the
light has gone out before driving.
N00520700170
This light comes on when the engine oil pres-
sure is below normal. If the light stays on
while driving, stop the engine as soon as pos-
sible. Do not run the engine until the cause of
the low oil pressure is corrected.
N00575700011
This light comes on in red if the coolant tem-
perature becomes excessively high.
CAUTION
Driving for a long time with the engine mal-
function indicator on may cause more dam-
age to the emission control system. This
could also affect fuel economy and drivabil-
ity.
If this indicator does not come on when the
ignition switch is turned to the “ON” posi-
tion or the operation mode is put in ON, have
the system checked at an authorized
Mitsubishi Motors dealer or a repair facility
of your choice.
If the engine malfunction indicator comes on
while the engine is running, avoid driving at
high speeds.
During vehicle operation with the indicator
on, the vehicle may not accelerate when you
depress the accelerator pedal.
When the vehicle is stationary with the indi-
cator on, you must depress the brake pedal
more firmly than usual since the engine
idling speed is higher than usual and a vehi-
cle with a CVT has a stronger tendency to
creep forward.
NOTE
Do not disconnect the battery cable when the
engine malfunction indicator (“SERVICE
ENGINE SOON” or “Check engine light”) is
on.
The engine electronic control module stores
critical OBD information (especially exhaust
emission data), which may be lost if the bat-
tery cable is disconnected while the engine
malfunction indicator is on. This will make it
difficult to diagnose the cause of future prob-
lems.
Charging system warning light
CAUTION
If the warning light stays on while the engine
is running, park your vehicle in a safe place
as soon as possible and contact an authorized
Mitsubishi Motors dealer or a repair facility
of your choice to have the system checked.
Oil pressure warning light
CAUTION
If this light comes on when the engine oil
level is not low, have your vehicle checked at
an authorized Mitsubishi Motors dealer or a
repair facility of your choice.
This warning light does not show the amount
of oil in the crankcase. This can only be
determined by checking the oil level with the
dipstick with the engine turned off.
High coolant temperature
warning light - red
BK0212400US.book 73 ページ 2014年4月1日 火曜日 午後2時21分
Information Provided by:

Table of Contents

Other manuals for Mitsubishi MIRAGE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi MIRAGE and is the answer not in the manual?

Mitsubishi MIRAGE Specifications

General IconGeneral
BrandMitsubishi
ModelMIRAGE
CategoryAutomobile
LanguageEnglish

Related product manuals