Mitsubishi MIRAGE Service Manual

Jack and tools
For emergencies 8-5
8
10. Replace the radiator cap and tighten it
fully. Check the coolant temperature
warning light. You can start driving again
when the high coolant temperature warn-
ing light does not come on.
11. Have the system inspected by your autho-
rized Mitsubishi Motors dealer or a repair
facility of your choice.
N00836600379
The tools are stored beneath the floor board
of the cargo area. The jack (if so equipped) is
stored under the driver’s seat.
Before removing or storing the jack, move
the driver’s seat fully forward to access the
jack from the rear seat area.
(Refer to “Front seat” on page 4-3.)
Turn the shaft end of the jack in the direction
(1) until the jack fully retracts and remove the
jack from the holder (A).
Put the jack in the holder (A) and turn the
shaft end of the jack in the direction (2) by
hand until the jack is firmly secured.
Jack and tools
Storage
1- Tools
2- Jack (if so equipped)
Tools
1- Tools bag
2- Wheel nut wrench
Type A
Type B
3- Jack bar
4- Towing hook
Jack (if so equipped)
CAUTION
 Never access, remove or store the jack from
the front of the driver’s seat. Doing so could
damage electrical wires under the driver’s
seat.
To remove
To store
BK0212400US.book 5 ページ ２０１４年４月１日 火曜日 午後２時２１分
Information Provided by:

Mitsubishi MIRAGE Specifications

General

Brand	Mitsubishi
Model	MIRAGE
Category	Automobile
Language	English