Mitsubishi MIRAGE Service Manual

Automatic air conditioning (if so equipped)
Comfort controls 7-13
7
Refer to “Personalizing the air conditioning
switch (Changing the function setting)” on
page7-15.
Refer to “Personalizing the air selection
(Changing the function setting)” on
page7-14.
N00737100208
To change the amount of air flowing from the
vents, press the MODE switch. Each time the
MODE switch is pressed, the mode changes
to the next one in the following sequence:
“”  “”  “”  “”  “”.
The selected mode is shown in the display
(A). Refer to “Changing the mode selection”
on page 7-2.
N00703400015
When this switch is pressed, the mode
changes to the “ ” mode. The indicator
light (A) will come on. The selected mode is
shown in the display (B). Refer to “Changing
the mode selection” on page 7-2.
N00737200368
Normally, use the outside air position to keep
the windshield and side windows clear and to
quickly remove fog or frost from the wind-
shield.
To change the air selection, simply press the
air selection switch.
The selected position will be shown in the
display (A).
 Outside air: “ ” indicator is ON
Outside air is introduced into the passen-
ger compartment.
 Recirculated air: “ ” indicator is ON
Air is recirculated inside the passenger
compartment.
When the air conditioning turns on, the air
selection is controlled automatically. When
MODE switch
Defogger switch
NOTE
 When the defogger switch is pressed, the air
conditioning system automatically operates
and outside air (as opposed to recirculated
air) is selected.
Refer to “Defrosting or defogging (wind-
shield, door windows)” on page 7-16.
Air selection switch
BK0212400US.book 13 ページ ２０１４年４月１日 火曜日 午後２時２１分
Information Provided by:

Mitsubishi MIRAGE Specifications

General

Brand	Mitsubishi
Model	MIRAGE
Category	Automobile
Language	English