Mitsubishi MR-JE-200A - Page 65

3. DISPLAY AND OPERATION SECTIONS
3 - 16
(b) Setting of 6 or more digits
The following example is the operation method to change the position data of the point table No. 1 to
"123456".
The display blinks.
Press "SET" once.
Press "SET" once.
Setting of upper 1 digit
Change the setting with
"UP" or "DOWN".
Press "SET" once.
Enter the setting.
Press "MODE" once.
Press "MODE" once.
Setting o
f
lower 4 digits
…… ……
……… ……
Press "MODE" four times.
A point table No. is displayed.
Press "UP" or "DOWN" to select
point table No. 1.
Press "SET" once.
………