Mitsubishi TEJ50AE - Displaying maintenance information

-
33
-
1
5
2
6
3
7
9
4
8
10
4 Initial setting
Displaying the maintenance information
4 初期設定
RUN/STOP
F2
PRESET
MENU
DEFROST
F3 F4F1
1
⇒
Press “MENU” switch.
The display changes to the “Main menu” screen.
⇒
2
Press “F2 (▲)” or “F3 (▼)” switch
till the display changes to the
“Maintenance information” mode.
3
Press “F4 (Select)” switch.
Display of Time to replace parts
・If the operation time or number of
operations reaches the Maintenance
required time on each device, this
screen (Right gure) is displayed for
10 seconds after the start of
operation of the refrigeration unit.
・If you press “F4 (Next)” switch, the
display changes to each parts in the
table next page. In case part other
than listed in the table is displayed
when pressing “F4 (Next)”, it is the
maintenance required part. The
replacement of part that is listed in the table should be done based on the
interval of the table.
・If you press “F2 (Reset)” switch after replacing the part, the operation time
and the number of START/STOP cycles are cleared.
F2 F3 F4
F2 F3 F4F1
F2 F3 F4F1
F1
“Total operation time” is displayed.
1
2 3
NextBack
Maintenance information
Total operation time/2120Hr
▲ ▼ SelectBack
Main menu
▲
▼
Alarm
Maintenance information
Language
NextBack
Maintenance information
Total operation time/2120Hr
Reset
NextBack
Maintenance information
Standby operation time/****Hr
Time to replace parts