-
60
-
1
5
2
6
3
7
9
4
8
10
9 For emergency
Alarm display
RUN/STOP
F2
PRESET
MENU
DEFROST
F3 F4F1
●If any error occurs, the abnor-
mal display lights or blinks
on the LCD (the backlight lights
or blinks).
●Check the alarm code displayed
at the right-hand side of the
abnormal display. (If it is a light
error, the alarm content at the
right-hand side of the alarm code is not displayed.)
When no error code is displayed at the LCD, change to the alarm display as
described below, and check the alarm content.
.
7
20
°
C
-
Set
E010 HP abnormally high
0
- .
°
C
30
Abnormal display
Alarm code
Alarm content
ClearBack
Alarm
E010
E016
E013
16 Jan 2021 07:10
15 Jan 2021 08:15
30 Nov 2020 10:30
Next
Switching "Normal display" and "Alarm display"
- 53 -
9 For emergency
1
5
2
6
3
7
4
Alarm display
●
When any trouble occurs, the warning icon
lights (backlight blinks) or blinks.
Check the alarm code displayed in the
●
digital display area.
When no alarm codes are displayed in the
digital display area, switch the screen to
the "Current alarm display" manually in
the following procedure, and check the
contents.
Switching "Normal display" and "Current alarm display"
Switching from "Normal display screen" to "Alarm display mode"
Press once each on the [MENU] switch, [F3( )] switch and [F4(Select)] switch.
(The display returns to the "Normal display screen" 20 seconds later.)
Switching from "Alarm display mode" to "Normal display screen"
Press the [F1(Back)] switch 2 times on the extended display of "Alarm display
mode". (The screen changes to "Normal display screen" in 20 seconds in case
of 1 press.) or hold down [MENU] switch.
Countermeasures
Refer to "List of alarm codes" for the contents of each alarm code and its
countermeasure. (
Refer to pages 62 and 63)
Surely follow the instructions of this operation manual
for the countermeasures of the troubles.
Otherwise, it may cause injury or an electric shock due to •
unexpected start.
When you contact your nearest dealer
When you contact your nearest dealer for the trouble occurred during
operation of the refrigeration unit, give them the following information.
Company name
●
Kind of cargo
●
Customer’s name
●
Setting temperature
●
Company telephone number
●
Present inside container
●
temperature
Number of the plate
●
Type of the refrigeration unit
●
Specific condition of trouble
●
Present location of the vehicle
●
Alarm code displayed in the
●
LCD display area.
Destination
●
Resuming operation after an emergency stop
Resuming operation after an emergency stop
Press the [RUN/STOP] switch on the cabin controller to stop the unit.
●
(Confirm that the LCD display is turned off.)
Press the [RUN/STOP] switch once more to resume the operation of the
●
unit.
If the unit stops by the same trouble immediately after
the operation is resumed, stop the operation and
contact your nearest dealer.
Otherwise, it may cause serious damages or accidents.•
CAUTION
CAUTION
To Next Page
Loading...
