-
9
-
(2) Select the gradation to be adjusted among three
different patterns (16, 32, and 48) using the left or
right shift key of the PC with only the curve of the
adjusted color displayed. These values show the
levels of gradation to be adjusted. Select one
pattern according to the following.
16 : To adjust darker color in the image
32 : To adjust half tone color
48 : To adjust brighter color in the image
Note: To make the left and right shift keys of the PC valid,
move the cursor to Gradation to be adjusted or Value.
(3) After selecting a pattern, adjust the value using
the up or down shift key of the PC. (When the
value is increased, the color gets deeper, and
when it is decreased, the color gets lighter.)
(4) Click “Adjustment” to reflect the adjusted value on
the projected image as well as to save such value
in the EEPROM. When the access to the
EEPROM succeeds, a response will be sent back.
(5) Use “Init” to initialize the value in the middle of
adjustment. To reflect the adjusted value on the
projected image as well as to save such value in
the EEPROM, be sure to click “Adjustment.”
To Next Page
Loading...
Need help?
General
