About the laser beam
This remote control is a Class 2 laser product. (Max. output : 1 mW, Wavelength :
640-660 nm)
Beam Divergence : 6m distance about 10.0mm x 10.0mm (±6.0mm)
CAUTION
• Pressing the LASER button on the remote control emits a laser beam. Do not look
into the laser beam directly. Do not point the laser beam at anyone. Looking at the
laser beam directly may damage eyesight.
• Use of controls or adjustments or procedures other than those specified herein
may result in hazardous radiation exposure.
1 Laser aperture
2 Transmission window
3 Indicator
4 POWER button
5 KEYSTONE button
6 EXPAND button
7 + , – (VOLUME) buttons
8 Mouse pointer
9 MENU button
10 STILL button
11 MUTE button (Audio/Video)
12 16 : 9 button
13 ENTER button
14 R-CLICK button (For mouse)
15 Direction buttons
16 LASER button
17 AUTO POSITION button
18 PinP button
19 VIDEO 1, 2 buttons
20 COMPUTER button
21 Left click button (For mouse)
• The + and - buttons are used in the KEYSTONE adjustment
and the EXPAND mode in addition to the volume control.
• Pressing the LASER button emits a laser beam. Even when
you keep holding down the LASER button, it is emitted only
one minute. To keep emitting it longer, press the LASER
button again.
• You can disable the LASER button to prevent laser radiation
due to misuse of the button.
How to disable the LASER button
While holding the LASER button down, press the button
three times.
How to enable the LASER button
While holding the LASER button down, press the button
three times.
• When the batteries are changed, the LASER button will be
enabled.
ABOUT LASER BEAM
To Next Page
Loading...
Need help?
General
