Mitutoyo ID-H0530 - Page 29

No. 99MAH016B
5-2
*2. Press and hold the [MODE] key slowly to switch to the Parameter Setup
mode.
*3. Press the [MODE] key quickly to clear the error using the procedure in *1
and *2 “Error 30” message.
*4. Press and hold the [MODE] key slowly to blink the “<>” symbol and
make tolerance setup ready, or press and hold the [SET/ZERO] key
slowly to display a maximum permissible display value and set tolerance
limit values.
NOTE
 If data input/output is not performed properly, there is a possibility of an error
in communication setup. Check the settings of this instrument and the
connected device.
 For detailed information about the RS-232 output command, refer to section
4.2.
 If any of the above errors occurs during function lock, press and hold the
[DATA/Fn] key for 2 seconds or more to cancel the function lock, and then
perform the error clear processing.