Mitutoyo ID-H0530 - Details of the LCD Unit

No. 99MAH016B
1-2
1.2 Details of the LCD Unit
(1) Function lock
(2) Output format display
(3) Upper over-range
(4) Upper pointer
(5) Pointer
(6) Lower pointer
(7) Lower over-range
(8) Analog range
(9) Tolerance judgment
(10) Maximum value hold measurement
(11) Runout hold measurement
(12) Minimum value hold measurement
(13) Display value unit
(14) Preset value setup mode
(15) Comparison measurement
(16) Data hold mode
(17) Reverse direction measurement
NOTE
 When tolerance judgment measurement is performed, the upper pointer (4) and lower
pointer (6) blink at slow intervals to indicate the upper limit value and lower limit value,
respectively.
 In the total runout, maximum value, or minimum value hold measurement mode, the
upper pointer (4) and lower pointer (6) blink to indicate the maximum value and
minimum value, respectively.
 If the pointer (5) coincides with the upper pointer (4) and lower pointer (6), these
pointers blink at quick intervals.
1
8
6
5
4
3
2
10
9
14
13
12
11
16
15
17
7