Mounting/Dismounting
30
05/01 AWB2700-1384GB
Step 5
Plug the electronics module onto the base element by pushing the
rails on the housing into the guide channels on the base element.
Push home until the electronics module clicks onto the base
element. The electronics module and base element are locked
together by the locking clips (see Step 6).
Figure 10: Fitting of the electronics module
Once coded, the electronics module cannot be inserted incorrectly,
due to inputs and outputs being clearly identified.
h
Additional misfitment security can be achieved by labelling the
base elements and electronics modules with the corresponding
station address, e.g. using hinged labels on the base elements.
To Next Page
Loading...