RS03/06-S/Q Hardware Manual RS03/06-S/Q Hardware Manual
9
9 / 28 / 2015
+86-400-820-9661
2.2 Mounting the Hardware
Use the M3 or M4 screw to mount the RS series drive .The drive should be securely fastened to a
smooth ,flat metal surface the will help conduct heat away from the chassis. If this is not possible,
forced airflow from a fan maybe required to prevent the drive from overheating.
• Never use the drive where there is no airflow or where other devices cause the
surrounding air to be more than 40
°
C (104
°
F).
• Never put the drive where it can get wet.
• Never use the drive where metal or other electrically conductive particles can
infiltrate the drive.
• Always provide airflow around the drive. When mounting multiple RS drives
near each other, maintain at least 1.5cm of space betwee
n drives.
To Next Page
Loading...
