Moons' STB Series - Connecting the Power Supply

13
Rev. 1.0
09/06/2015
MSSTB-R/C Hardware Manual
400-820-9661
2.5 Connecting the Power Supply
Connect power supply “+” terminal to the drive terminal labeled “V+”.
Connect power supply “-” terminal to the drive terminal labeled “V-”.
MSSTB05 accepts DC voltage range from 24 – 48VDC
MSSTB10 accepts DC voltage range from 24 – 70VDC
Warning: DO NOT reverse the wires
NOTE: DO NOT apply power until all connections to the drive have been made
V+
J1
V-
Power Connector
Ensure a proper earth ground connection by using the screw on the left side of the chassis.
To Earth Ground
Please read “choosing a power supply” for more details.