6
Rev. 1.0
09/06/2015
MSSTB-R/C Hardware Manual
400-820-9661
2 Getting Started
The following items are needed:
• A 24-48VDC power supply (24-70VDC power supply for MSSTB10), see the section below
entitled“Choose a Power Supply”for help in choosing the right one.
• A compatible stepper motor, please see the section below entitled “Recommended Motor”
• A small flat blade screwdriver for tightening the connectors screw(included)
• A PC running Microsoft Windows XP / Vista / Windows 7/ Windows 8(32-bit or 64-bit)operation
system
• Install STB Congurator software (Available from MOONS’website)
• -R model
For MSSTB05-R drive, a RS-485 daisy chain communication cable is included in the package.
It is used for connection with the next drive in the RS-485 network. It can also be used for
connection with PC for drive configuration.
For MSSTB10-R drive, a network cable is included in the package. It is used for connection
with the next drive in the RS-485 network. It can also be used for connection with PC for drive
configuration.
• -C model
A RS-232 programming cable(included in the package)
For MSSTB05-C drive, a CANopen daisy chain communication cable is included in the
package. It is used for connection with the next drive in the CANopen network.
For MSSTB10-C drive, a network cable is included in the package. It is used for connection
with the next drive in the CANopen network.
TIP: When connecting the rst drive in the RS-485 or CANopen network with PC or controller. you
can cut the daisy chain cable or network cable into two: one half is used for connection with the
RS-485 or CANopen port on the PC or controller, the other half can be used for connection with
termination resistor, which can be put at the end of the network.
To Next Page
Loading...
Need help?
General
