Moore Industries SPA2 - Safety Messages; Safety Symbols Definitions; Qualified Personnel Requirements

www.miinet.comMoore Industries-International, Inc.
- 3 -
User’s Manual
224-790-00K
May 2018
Safety Messages
Please read this manual in its entirety. It should answer most of your questions. For personal and system safety, and for
optimum product performance, make sure you thoroughly understand the contents before installing, using, or maintaining this
product. Should you still have questions please visit our web site at www.miinet.com or contact any of our sales/support o󰀩ces
nearest you.
Your safety and the safety of others is very important. We have provided many important safety messages in this manual.
Please read these messages carefully. These safety messages alert you to potential hazards that could hurt you or others or
render damage to units.
All Moore Industries instrumentation should only be used for the purpose and in the manner described in this manual. If you
use this product in a manner other than that for which it was intended, unpredictable behavior could ensue with possible
hazardous consequences.
Each safety message is associated with a safety alert symbol. These symbols are found in the throughout the manual. The
denition of these symbols is described below:
Pay particular attention wherever you see the following symbols:
Note – Information that is helpful for a procedure,
condition or operation of the unit.
Caution – Hazardous procedure or condition that
could damage or destroy the unit.
Warning – Hazardous procedure or condition that
could injure the operator.
Qualied Personnel
The Moore Industries’ product/systems described in this manual may be operated only by personnel qualied for the specic
task in accordance with the relevant documentation, in particular its warning notices and safety instructions. Qualied
personnel are those who, based on their training and experience, are capable of identifying risks and avoiding potential
hazards when working with these Moore Industries’ products/systems.
Proper use of Moore Industries products
Moore Industries’ products may only be used for the applications described in the catalog and in the relevant technical
documentation. If products and components from other manufacturers are used, these must be recommended or approved by
Moore Industries’ . Proper transport, storage, installation, assembly, commissioning, operation and maintenance are required
to ensure that the products operate safely and without any problems. The permissible ambient conditions must be complied
with. The information in the relevant documentation must be observed.
We have reviewed the contents of this publication to ensure consistency with the hardware and/or software described. Since
variance cannot be precluded entirely, we cannot guarantee full consistency. However, the information in this publication is
reviewed regularly and any necessary corrections are included in subsequent editions. Specications and information are
subject to change without notice.
All product and company names are trademarks™ or registered
®
trademarks of their respective holders. Use of them does
not imply any a󰀩liation with or endorsement by them unless otherwise specied.
Programmable Limit Alarm Trips
SPA
2
About this Manual