Pre Start Inspection and Operation
3.19
Installation of Non-Hydraulically Powered Attachments
There are many available attachments that are very easy to install. To install any of the non-
hydraulically powered attachments:
1. Position the attachment on a level surface.
Clean the inside lower edge of the female attachment mounting plate to remove any debris
that might interfere with the attachment installation.
2. Start the machines engine, lower the loader arm and tilt the mounting plate forwards.
Make sure that both of the attachment lock pins (Item 1, Figure 3–23) are in the “unlocked”
position. See Attachment Lock Pins earlier in this section.
3. When the top of the attachment mounting plate (Item 1, Figure 3–24) is rmly seated in
the attachment mounting bracket (Item 2, Figure 3–24), tilt the attachment mounting plate
backward slightly to allow the lower edge of the attachment mounting bracket to slide into
place on the attachment mounting plate.
Figure 3-24 Non-powered Attachment Installation
4. When the machines mounting plates top edge is seated in the attachment mounting plate,
curl the machines mounting plate backwards slightly to allow the lower edge of the
machines mounting plate to slide into position. See Figure 3–25.
NOTICE
NOTICE
1
2
To Next Page
Loading...
