Morbark BOXER 320 - Troubleshooting Machine Issues; Engine Start and Power Problems

5.1
Section 5 - Troubleshooting
The following procedures will assist you in determining the potential cause of a machine
operating problem.
Make sure to follow all safety precautions stated in this manual when
doing any work on the machine.
Problem Possible Causes Corrective Action
Starter does not turn the
engine over.
• Auxiliary hydraulics lever is
either in Forward or Reverse
position with no hydraulically
powered attachment installed.
• Move lever to neutral position.
• Battery is dead. • Charge the battery, if battery
does not hold a charge,
replace the battery.
• Electrical connections are
corroded or loose.
• Check electrical connections
for good contact.
• Remove cables from battery
terminals and fully clean
terminals and cable clamps,
if the cable clamps can not
be properly cleaned, replace
connectors.
• Relay or starter switch is
defective.
• Contact Authorized Service
Dealer.
• Engine is in hydraulic lock
due to a cylinder lled with
fuel.
• Contact Authorized Service
Dealer.
NOTICE