Morbark BOXER 320 - Daily and Weekly Maintenance Procedures

Routine Service and Maintenance
4.2
Daily Maintenance Procedures
Do the following procedures daily or every 10 operating hours:
1. Check condition of all warning and instructional decals. Before operating the machine,
replace any missing or damaged decals.
Make sure to read and understand all WARNING and SAFETY decals before
operating the machine.
• Allow engine to cool before lling fuel tanks.
• Do not overll because fuel could spill onto hot engine parts and ignite or
explode.
• Make sure engine is turned o.
2. Check engine fuel and ll as needed - be sure engine is OFF.
a. The Boxer has one saddle tank (Item 1, Figure 4–1), on the left side of the machine.
Figure 4-1 Fuel Level Check
b. The fuel tank has a fuel gauge located in the ller cap (Item 2, Figure, 4-1). Remove cap
and visually inspect fuel level to make sure that the indicator is showing the proper fuel
level. Make sure that the tank has been lled on a daily basis.
Carefully pour gas into the tank, not exceeding the max ll indication shown by the
gauge in the fuel cap.
NOTICE
CAUTION
E
F
2
1