Motocaddy M-TECH - Front Wheel and Anti-Tip Wheel; Adjusting Front Wheel Alignment; Attaching the Anti-Tip Wheel

Page 11
FRONT WHEEL ALIGNMENT / ATTACHING THE ANTI-TIP WHEEL
Adjusting the Front Wheel Alignment
If your trolley is not tracking in a straight line, the alignment of the front wheel can be adjusted to rectify.
This can be caused by a number of factors including a slightly loose bag support or unevenly packed bag.
1. Lift the quick release lever positioned on the front wheel housing and loosen the wheel nut (g. 1)
2. There are two small metal dials on either side of the housing that are used to realign the wheel (g. 2)
3. If your trolley is veering to the right (when walking behind it), turn the left hand dial clockwise and the
right hand dial anti-clockwise
4. If your trolley is veering to the left (when walking behind it), turn the right hand dial clockwise and the
left hand dial anti-clockwise
5. Tighten the wheel nut and push down the lever to lock the wheel back into place (g. 3)
This procedure can be carried out until you are happy the trolley is moving in a straight line. You may only
need to adjust one dial at a time.
Instructions based on being in front of the trolley looking at the wheel whilst it is in front of the housing.
Attaching the Anti-Tip Wheel (Optional)
The Anti-Tip wheel is designed to prevent the trolley from tipping backwards on steeper inclines and is
included with the M-TECH GPS as an optional attachment. It is not a requirement for safe use.
To attach the wheel, simply pull the grey button on the right side of the anti-tip wheel housing (located
underneath rear of trolley) out and slide the anti-tip wheel bar into the housing. There will be a ‘click’ when
the wheel is securely tted. To remove the wheel, pull the grey button out and slide the attachment out of
the housing. The wheel can be removed, or pushed underneath the trolley when not in use.
Fig 1
Fig 2
Fig 3