2.3.3
Erasing Bluetooth Headset History and Adding Bluetooth Headset
Prerequisites: Turn the radio off.
Procedure:
1 Put the Bluetooth headset in pairing mode. Refer to your Bluetooth headset instructions leaflet.
2 Press and hold the Menu and Power buttons simultaneously until your radio shows the blue
LED.
NOTE: The CLP radio uses proximity pairing. Ensure the headset is close enough to the
CLP radio. Pairing process takes about 14 seconds.
2.4
Turning the Radio On or Off
Procedure:
1 To turn on the radio, press and hold the Power and Battery button until you hear a short tone
and the Smart Status Glow Ring illuminates.
2 To turn off the radio, press and hold the Power and Battery button until you hear a short tone
and the Smart Status Glow Ring indicator blinks once.
2.5
Adjusting the Volume
Procedure:
1 To increase the volume, press the + button.
NOTE: Radio has 16 increments of volume.
2 To decrease the volume, press the – button.
2.6
Inserting and Removing the Swivel Belt Clip Holster
The radios offer various flexible carrying accessories. For Motorola Solutions approved accessories
list, refer to http://www.motorolasolutions.com/CLP.
Procedure:
1 To insert the radio into the holster, perform the following steps:
a Slide the bottom of the radio into the holster.
b Snap the top of the holster into the radio around the accessory connector.
2 To remove radio from the holster, pull either the top or bottom tab and pull the radio from the
holster.
NOTE: For optimal plug retention, loop the cord into the recess in the rear of the holster
when using a corded audio accessory.
68012000044-ED
Chapter 2 : Getting Started
14
To Next Page
Loading...
Need help?
General
