Figure 9: Charging Radios
3.9
Charger LED Indications
On the drop-in charger, the radio charging pocket has an LED Charger.
On the Multi-Unit Charger (MUC), each of the six charging pockets has an LED. The LEDs are
grouped into pairs to indicate which charging pockets are paired.
NOTE: You can clone up to two source radios and two target radios using MUC. For more
information on cloning, see Radio Cloning on page 31.
For part number details, see Accessories on page 47.
Table 6: Charger LED Indicator
Status LED Indication
Battery is charging Steady Red
Battery is fully charged Steady Green
Battery Fault
1
Blinking Red
NOTE: The LED is red when the battery is charging. It turns green once the battery is
fully charged.
3.10
Charging the Bluetooth Headset
Follow the procedure to charge bluetooth headset with CLP Series Drop-In Tray Multi-Unit Charger
(MUC) and cloning cable. This is an optional accessory.
1
Re-seat the battery pack to correct the faulty battery issue.
68012000044-ED
Chapter 3 : Battery and Charger
25
To Next Page
Loading...
Need help?
General
