Motorola CLP1010 User Manual

a Press Menu button to navigate to Scan.
b Press the + to activate or the – button to deactivate scan.
4 Sending Call Tone:
Enabled through Customer Programming Software (CPS).
a Press Menu button to navigate to Call Tone.
b Press the + or the – button to send call tone.
2.9
Selecting Channels
The following procedures are for multi-channel models only.
Procedure:
1 Press the Menu button.
You hear a voice prompt to change channel by pressing the + or – button.
2 Select the required channel.
The LED indicates the color of the new channel.
3 Press the PTT button to confirm or the channel is activated after three seconds hang time.
2.9.1
Default Channel Settings for CPS
The table describes the default channel settings for Customer Programming Software (CPS).
Table 3: Channel Settings for CPS
CLP1010 Single-Channel
Models
CLP1040 Multi-Channel
Models
CLP1060 Multi-Channel
Models
Chan-
nel
LED
Status
Color Chan-
nel
LED
Status
Color Chan-
nel
LED
Status
Color
1 Red 1 Red 1 Red
2 Green 2 Green
3 Yellow 3 Yellow
4 Blue 4 Blue
5 Purple
68012000044-ED
Chapter 2 : Getting Started
17

Motorola CLP1010 Specifications

General

Brand	Motorola
Model	CLP1010
Category	Two-Way Radio
Language	English