Customer Services Publishing
Easter Inch, Bathgate, West Lothian
EH48 2EH, United Kingdom
DTest4
© Motorola Ltd. 1997
All Rights Reserved
Printed in U.K.
DCS 1800 StarTAC PERSONAL
CELLULAR TELEPHONE
MANUAL-TEST MODE & VERIFICATION
MANUAL-TEST MODE
68P09304A85
19/07/97
13
Cellular Subscriber Group
MANUAL-TEST MODE
1. INTRODUCTION
The Motorola DCS 1800 StarTAC personal cellular
telephones are equipped with a manual-test mode capability.
This capability allows service personnel to take control of
the telephone, and by entering certain keypad sequences,
make the telephone perform desired functions. To enter the
manual-test mode, a Test SIM card (Part No 8102316T01)
is required.
2. TEST SIM CARD INSERTION
REMOVAL
The Test SIM card must be inserted into the unit correctly to
access manual-test mode. The whole SIM card should slide
completely and securely into the slot at the base of the
phone. Ensure that the contacts of the card face towards the
front of the phone i.e. towards the keypad.
The sliding, card release button will move upwards as the
SIM card is inserted. When the button reaches the top of its
recess and the card is flush with the base of the phone, it is
inserted correctly. To remove the SIM card from the unit,
push the sliding SIM card release button downwards. The
card will then be pushed out far enough to allow complete
removal.
The User Guide contains full information about inserting
and removing the SIM card.
3. ACCESSING THE MANUAL-TEST MODE
When the Test SIM card is in place, power up the telephone.
Once the initial automatic ‘wake up’ sequence has taken
place correctly, depress the # key (on the units keypad) for
three seconds. After three seconds ‘TEST’ should appear in
the display, indicating that the unit is now in the manual-test
mode. Table 1 below shows the available manual-test
commands and their corresponding results.
Note:
* Please use this command with caution as any customer
information stored in the unit will be lost
** If a customer should forget the security code in their unit,
it can only be read or changed by using a Test SIM card.
Command Result
01# Exit manual-test mode
19# Display call processor s/w version
20# Display modem s/w version
22# Display speech coder s/w version
57# * Initialize non-volatile memory
58# ** Display security code
58xxxxxx# ** Change security code
59# Display lock code
59xxx# Change lock code
60# Display International Mobile station
Equipment Identity (I.M.E.I.)
Table 1
To Next Page
Loading...
