Customer Services Publishing
Easter Inch, Bathgate, West Lothian
EH48 2EH, United Kingdom
DTest4
© Motorola Ltd. 1997
All Rights Reserved
Printed in U.K.
DCS 1800 StarTAC PERSONAL
CELLULAR TELEPHONE
MANUAL-TEST MODE & VERIFICATION
Cellular Subscriber Group
68P09304A85
19/07/97
15
1
7
VERIFICATION
1. INTRODUCTION
To test a DCS 1800 StarTAC cellular telephone, to verify
whether or not the unit is functioning correctly, the
following equipment will be required:-
• D.C.S. compatible communications analyser.
• Cable/connectors (SKN4779A) .
• Test SIM card (8102316T01).
• Charged battery pack.
2. EQUIPMENT CONFIGURATION
Initially insert the test SIM card into the slot at the rear of the
personal cellular telephone. If required, further information
on SIM card insertion is available on page 13. Attach the
antenna adaptor to the antenna connector of the phone. Slide
a charged battery on to the back of the personal telephone,
so that the telephone can be powered up. Finally, connect a
cable from the test adaptor to the RF in/out port of the
communications analyser, and power both the analyser and
personal telephone on. The equipment set up shown in
Figure 1 should now be in place.
Figure 1: Testing Configuration
D.C..S . COMPATIBLE
COMMUNICATIONS ANALYSER
RF IN/OUT
PORT
32
4 6
5
98
0
c
MR
M+
StarTAC
SMA Plug
OK
MENU
SKN4779A
CABLE
12:00
DEF
MNO
*
#
ABC
JKL
GHI
PQRS
TUV
WXYZ
+
To Next Page
Loading...
