68P09304A82-O FPers6
24 1/9/97
68P09304A85-O FPers6
24 19/07/97
DCS 1800 starTAC CELLULAR TELEPHONE
6. MASTER TRANSFER
This method of transfer should only be followed when the
defective unit will not power up, or complete a Normal
Transfer. As mentioned earlier, there may be different
variations (OEM looks for example) of the Motorola DCS
starTAC cellular telephone, each model requiring the main
board to be configured differently for correct operation.
When carrying out a Master Transfer it is not possible to
transfer the customers selected features or stored phone
numbers, only the model personality can be programmed
into the repaired unit.
Each different version of the DCS starTAC cellular
telephone, requires its own Master Transfer card which
contains essential set up information. Master SIM cards may
be ordered pre-programmed, or created from a Normal
Transfer card. The instruction steps should be followed in
order.
Step 1. Select the required Master SIM card.
Step 2. Insert the Master Transfer card into the slot
located on the back of the repaired unit. Turn the
unit on, the display should show ‘Clone’.
Step 3. Enter 03# via the unit’s keypad. This command
will cause the configuration data to be
downloaded from the Master Transfer card.
Step 4. While data transfer is taking place between the
card and the unit ‘Please Wait’ will be
displayed. After a short period of time, if the
data transfer has been completed correctly,
‘Clone’ will re-appear in the recipient unit’s
display.
Step 5. When the data block has been transferred
successfully, remove the Master Transfer card
and check the radio functions correctly. See
page 19 for details.
At no point should either 021#, 022# or 025# be entered
while a Master Transfer card is in the radio. If either of the
stated commands are entered, the master information on the
card will be erased. To prevent the above happening the card
can be locked by entering 06# via the unit’s keypad, with the
card inserted. Unlock the card by entering 07#.
Note: If during either transfer process a problem arises, an
error message will be displayed. If the Transfer card
is removed before the data transfer is completed
‘Bad Data on Card’ will appear in the display. If
either situation arises, the process should be
repeated.
7. MASTER SIM CARD CREATION
When required a Master SIM card can be created by:-
Step 1. Insert a Transfer card into a unit which is
already configured in the desired way. Turn the
unit on, the display should show ‘Clone’.
Step 2. Enter 024# via the unit’s keypad. This command
copies the personality information in the unit
onto the Transfer card to create a Master
Transfer card.
Step 3. While data transfer is taking place between the
unit and the card ‘Please Wait’ will be
displayed. After a short period of time, if the
data transfer has been completed correctly,
‘Clone’ will re-appear in the recipient unit’s
display.
Step 4. A Master Transfer card has now been created.
Lock the card to prevent accidental information
erasure (see previous section). Remove the card
from the unit, and store until required.
To Next Page
Loading...
