98
HT/JT1000 Mode Switch
Functions
The Mode/Switch functions for HT/JT1000 radios are provided in the
table below:
Note: Where the switch position description says “Channel
Option Squelch” or “Channel Option Power”, refer to the
setting on the CHANNEL CONFIGURATION screens (F4/F4) for
the various channels to determine how this option will vary.
Mode Position A Position B Position C
1 Scan & Scan
Programming 1
Scan Program On
Scan Off
Scan Prog. Off
Scan Off
Scan Prog. Off
Scan On
2 Scan & Scan
Programming 2
Scan Prog. Off
Scan On
Scan Prog. Off
Scan Off
Scan Prog. On
Scan Off
3 Scan and Talkaround Direct
Scan Off
Repeat
Scan Off
Repeat
Scan On
4 Scan/Squelch Defeat Channel Op. Sq.
Scan Off
Carrier Squelch
Scan Off Scan On
5
#
Scan & PAC•RT
Operation
Tx PL/Low Pwr
Scan Off
Carrier Squelch
Scan Off
Carrier Squelch
Scan On
6 Talkaround Only Direct Repeat Repeat
7 Squelch Defeat Channel Op. Sq. Carrier Squelch Carrier Squelch
8
#
PAC•RT Tx PL/Low Pwr Carrier Sq. Tx
(PAC•RT)
Carrier Sq. Tx
(PAC•RT)
9
*
Hi-Low Power High Power Low Power Low Power
10
*
Hi-Low Power & Scan High Power
Scan Off
Low Power
Scan Off
Channel Op.
Power
Scan On
11 Talkaround/PL Channel Option Sq.
Repeat
Carrier Squelch
Repeat
Carrier Squelch
Direct
12 Scan Scan Off Scan On Scan Off
13 Scan/Channel Option
Talkaround
Channel Option
Talkaround
Scan Off
Repeat
Scan Off
Repeat
Scan On
14 Channel Option
Talkaround
Channel Option
Talkaround
Scan Off
Repeat
Scan Off
Repeat
Scan On
15 Blank No function No function No function
16 Unsupported Switch No function No function No function
*
Not available on JT1000 models and 800 MHz HT 1000 models.
#
Not available on 800 MHz models.
To Next Page
Loading...
