53
Controller Board
Initialization
From the MAIN MENU, press F2 and then F7 to access this screen.
This procedure should be performed whenever the radio’s Controller Board is
replaced. This process will initialize the replaced board with the radio’s
original serial number.
Programming Procedure 1. Enter a valid serial number. The RSS will NOT accept invalid serial
numbers. Enter the correct ten-digit serial number that is printed
on the radio’s label.
Note: Error messages will be displayed if the entered Serial
number is invalid, the model number of codeplug and
controller respectively do not match, or an attempt to
communicate with the radio results in failure.
2. Press F8. If the serial number entered is valid, a pop-up window
will be displayed as shown on the following page.
3. Press the appropriate key.
BG
MOTOROLA Radio Service Software Select a function key, F1-F10.
HT/JT1000/VISAR Model:
Serial:
SERVICE:CONTROLLER INIT
CONTROLLER BOARD INITIALIZATION
-------------------------------
Serial Number..
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP PROGRAM EXIT
RADIO
!
Caution
This procedure should be attempted only by qualified
service personnel. You will be allowed to program
the serial number ONLY ONCE. If the serial number
conforms to the correct format but contains erroneous
digits, the RSS will STILL program the radio. If this
happens, you will NOT be allowed to re-program the
radio with the correct serial number. Make sure you
enter the correct serial number the first time.
To Next Page
Loading...
