24
Transmit
Alignment Menu
From the MAIN MENU, press F2 twice to access the TRANSMIT
ALIGNMENT MENU.
Standard periodic alignment procedures are performed from this
menu. From here, you can navigate to six screens where various
alignment settings are specified. You should refer to the appropriate
(HT 1000, JT1000 or VISAR) Radio Service Manual for specific details
of these alignment procedures.
Signalling deviation for MDC, DTMF, or Single Tone must be checked
any time that the radio is serviced and must be adjusted whenever any
of the modulation circuitry is replaced. Before adjusting signalling
deviation, radio compensation/deviation adjustments must be made.
No adjustments are required however for DPL or TPL deviation.
BB
MOTOROLA Radio Service Software Please make sure <Caps Lock> is not
HT/JT1000/VISAR Model: enabled before pressing F2-F9.
Serial:
...SERVICE:XMTR ALIGN
TRANSMIT ALIGNMENT MENU
-----------------------
F1 - HELP
F2 - Reference Frequency Alignment
F3 - Transmit Power Alignment
F4 - Transmit Deviation Balance (Compensation) Alignment
F5 - Transmit Deviation Limit Alignment
F6 - Transmit Deviation Limit: Reference Softpot
F7 - Transmit VCO Crossover Alignment
F8 -
F9 -
F10 - EXIT
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP REF TRANSMIT DEV DEV DEV VCO EXIT
FREQ POWER BAL LIMIT REF XOVER
!
Caution
These procedures should only be attempted by
qualified service personnel. Failure to perform
alignment procedures properly may result in seriously
degraded radio or system performance.
To Next Page
Loading...
