65
Program Radio
Codeplug (Requires
RIB)
From the MAIN MENU, press F3 and then F8 to program the radio
codeplug.
This screen allows you to program the radio with the contents of the
current work space. A radio interface box (RIB) must be connected to the
computer’s serial port and the power turned on before you perform this
operation.
The first time you press F8 in the GET/SAVE/PROGRAM screen, a
displayed prompt will request you to press F8 again to program the
radio with the contents of the work space or to press F10 to cancel the
request. If the programming process is successfully completed, you
will see the following message: “Radio Was Successfully Programmed”.
You will then be returned to the GET/SAVE/PROGRAM screen
automatically.
Note: The time required to PROGRAM a codeplug will depend
directly on your computer type and the size of the codeplug
being programmed. The status of the programming operation
will be displayed on the screen.
CH
MOTOROLA Radio Service Software Select a function key, F1-F10.
HT/JT1000/VISAR Model :
Serial:
GET-SAVE-CLONE
Get-Save-Clone Menu
-------------------
F1 - HELP
F2 - Read Data from Radio
F3 - Get Workspace Data from Archive File
F4 -
F5 - Clone (Copy) Data to another Radio
F6 -
F7 - Save Workspace Data to Archive File
F8 - Program Data into Radio
F9 -
F10 - EXIT, Return to Main Menu
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP READ GET CLONE SAVE PROGRAM EXIT
RADIO FILE FILE RADIO
PROGRAMMING the radio will replace the contents of the radio’s
codeplug with the current contents of the workspace,
F8 - program the radio’s codeplug.
F10 - cancel request.
Press F8 or F10.
To Next Page
Loading...
