54
When initialization is completed, the radio’s codeplug will contain
default data. At this point, the radio should be tuned. When tuning is
completed, customer data can be programmed back into the codeplug
using one of the following methods:
• Cloning, where the customer’s feature data alone is replaced.
• Programming, where tuning data is also replaced along with the
feature data. If the radio’s codeplug (along with tuning data) was
saved to an archive file prior to initialization, this archive file can
be programmed into the radio after initialization. This process will
replace the default tuning data of the radio with data which is
valid for the radio’s RF board. Nevertheless, tuning should be
checked since some fields may need adjustment. This is still easier
than having to tune all parameters.
Function Key
Descriptions
F8 - PROGRAM RADIO Programs the radio with the serial number you provided.
MOTOROLA Radio Service Software Select a function key, F1-F10.
HT/JT1000/VISAR Model:
Serial:
SERVICE:CONTROLLER INIT
CONTROLLER BOARD INITIALIZATION
-------------------------------
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
HELP PROGRAM EXIT
RADIO
Program Codeplug with Serial Number 402ATE0340?
F8 - Continue
F10 - Abort
Press F8 or F10.
To Next Page
Loading...
