87
Permanent Monitor Use the UP/DOWN arrow keys to enable/disable this option. If this
option is enabled, the Permanent Monitor feature will be enabled in
the radio. To enter Permanent Monitor, the user will have to hold
down the radio’s Monitor button for the time period specified in the
Monitor Long Press Period field on this screen. The operation of
Permanent Monitor is determined by the setting in the Permanent
Monitor Definition field on this screen.
Note: The Permanent Monitor state will not be preserved across
channel changes or power cycling.
The default is Enabled.
Permanent Monitor Definition Use the UP/DOWN arrows to make your selection. The field is used to
specify the squelch mode of the radio during a momentary press of the
Monitor button or in Permanent Monitor mode. The two options are:
Note: The definitions above do NOT apply to Monitor during Scan
mode. Monitor operation during Scan is controlled by the PL Defeat
field on the SCAN CONFIGURATION screen (F4/F3/F8/F2).
The default is Open Squelch.
Possible Sidebutton
Setups for Scanning
Open Squelch The radio will be continuously unmuted.
PL Defeat The radio will be in Carrier Squelch during Monitor.
Operator Selectable Scan
Only
Sidebutton 1 = Scan/Scan Programming On/Off
Sidebutton 2 = Scan Programming Status Scroll
Operator Selectable Scan
with Monitor
Sidebutton 1 = Scan/Scan Programming On/Off
Sidebutton 2 = Monitor/Scan Programming Status Scroll
Operator Selectable Scan
with Nuisance Delete
Sidebutton 1 = Scan/Scan Programming On/Off
Sidebutton 2 = Select
Scan On/Off Only Sidebutton 1 = Scan On/Off
Sidebutton 2 = Any other function
Scan On/Off with
Nuisance Delete
Sidebutton 1 = Scan On/Off
Sidebutton 2 = Select
To Next Page
Loading...
