1 - 4 MC1000 with Windows CE 5.0 Integrator Guide
1. Pull back the two battery door latches.
2. Lift the battery door.
Figure 1-2
Battery Door Removal
3. With your index and middle fingers, place the battery adapter clip in the up position and push forward until it is
latched in position.
4. Insert the battery into the battery well top first.
Figure 1-3
Battery Insertion
5. Replace the battery door and press down until it snaps into place.
AAA Battery Installation
To install the optional AAA batteries:
1. Pull back the two battery door latches.
CAUTION The battery door might not closed properly if the battery adapter clip is not positioned correctly. Damage to
the battery adapter clip and battery door may occur.
Avoid touching the contacts when positioning the battery adapter clip.
Battery Adapter
Clip
Battery Door
Switch
NOTE The battery door switch detects if the battery door is installed properly. The mobile computer will not turn on if
the battery door in not in place.
To Next Page
Loading...
Need help?
General
