Chapter 6 Radio Tuning Procedure
General
An IBM PC (personal computer) and RSS (Radio Service Software)/CPS (Customer Program
Software) are required to align the radio. Refer to the applicable RSS Manual for installation, setup
procedures for the software and minimum computer requirements.
To perform the alignment procedures, the radio must be connected to the PC, RIB (Radio Interface
Box), and Test Set as shown inFigure 6-1.
Figure 6-1. Radio Alignment Test Setup
The use of Mini UHF Adapters will have damaging effects on
the RF Antenna Connector which might lead to radio failure.
!
a u t i o
BNC
RIB RLN4008
or
SRIB RLN1015
RIB POWER SUPPLY
0180357A57 (110VAC)
0180357A56 or EPN4041A (220 VAC.)/
EPN4040A (240 VAC.)
COMPUTER INTERFACE RIB CABLE
30-80369B71/72
or
COMPUTER INTERFACE SRIB CABLE
30-80390B48/49
DATA
BUSY
GND
COMPUTER
AUDIO GENERATOR
SINAD METER
AC VOLTMETER
TX
RX
30 dB PAD
30 dB PAD
RF GENERATOR
SERVICE MONITOR
OR COUNTER
WATTMETER
C/BATTERY
KN4191 or
KN6110
TRANSMIT
RECEIVE
TEST SET
RLN4460A or
GTF180B
RADIO
PROGRAM/TEST CABLE
RKN4062A, RKN4063A or GTF372A
AUDIO IN
MEPC-95029-A/GB
To Next Page
Loading...
Need help?
General