6809511A13-O April 20, 2007 25
Level 1 and 2 Service Manual Disassembly
4. Carefully rotate the rear housing away from the front housing and flip
assembly (see Figure 8).
5. Use the disassembly tool to unseat the flex connector from its socket.
6. Lift the rear housing assembly away from the phone.
7. To replace, carefully align the flex connector to it’s socket on the rear housing
assembly, then gently press down on the flex connector until it is properly
seated in it’s socket.
8. Rotate the rear housing assembly so it sits over the phone.
9. Align the housing latches with the corresponding openings on the front
housing. Gently press the housings together until the catches snap into place.
10. Replace the 2 housing screws and tighten to a final torque setting of (2.2 +/-
0.1 inch pounds). Do not over tighten.
11. Replace the SIM, battery, and battery cover as described in the procedures.
070588o
Figure 8. Removing the Rear Housing Assembly
G
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
FLEX Connector
Rear Housing Assembly
To Next Page
Loading...
