Permanent Monitor
The Permanent Monitor feature is used to continuously
monitor a selected channel for activity.
Turning Permanent Monitor On or Off
Follow the procedure to turn Permanent Monitor on or off
on your radio.
Press the programmed Permanent Monitor button.
When the radio enters the mode:
• An alert tone sounds.
• The yellow LED lights up.
When the radio exits the mode:
• An alert tone sounds.
• The yellow LED turns off.
Scan Lists
Scan lists are created and assigned to individual channels
or groups. Your radio scans for voice activity by cycling
through the channel or group sequence specified in the
scan list for the current channel or group.
Your radio can support up to 64 scan lists, with a maximum
of 16 members in a list.
Scan
Your radio cycles through the programmed scan list for the
current channel looking for voice activity when you start a
scan.
During a dual-mode scan, if you are on a digital channel,
and your radio locks onto an analog channel, it
automatically switches from digital mode to analog mode
for the duration of the call which is also true for the reverse.
There are two ways of initiating scan:
• Main Channel Scan (Manual) : Your radio scans all the
channels or groups in your scan list. On entering scan,
your radio may, depending on the settings,
automatically start on the last scanned active channel or
group, or on the channel where scan was initiated.
• Auto Scan (Automatic) : Your radio automatically
starts scanning when you select a channel or group that
has Auto Scan enabled.
English
38 Send Feedback
To Next Page
Loading...
